Which command should you enter to verify the priority of a router in an HSRP group?
The following is sample output from the show standby command:
The correct answer is D. show standby.
HSRP (Hot Standby Router Protocol) is a Cisco proprietary protocol that provides redundancy for IP networks by allowing two or more routers to share a virtual IP address. One router acts as the active or primary router, and the others are in standby mode.
To verify the priority of a router in an HSRP group, you can use the "show standby" command. This command displays information about the HSRP groups, including the router priority.
Here's how to use the command:
For example, if the HSRP group number is 1, and the output shows:
Router-1# show standby 1 GigabitEthernet0/0 - Group 1 Local state is Active HSRP active router is 192.168.1.1, priority 200 (expires in 00:00:34) Standby router is local Priority 100 (configured 100)
This output indicates that the local router is the standby router, with a priority of 100, and the active router has an IP address of 192.168.1.1 and a priority of 200. The active router will continue to be active until its priority is lowered below the standby router's priority, or it becomes unavailable.