Question 549 of 952 from exam 200-125: Cisco Certified Network Associate Exam

Prev Question Next Question

Question

Refer to the exhibit. Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

Answers

A. The cable that is connected to S0/0 on RouterA is faulty.

B. Interface S0/0 on RouterB is administratively down.

C. Interface S0/0 on RouterA is configured with an incorrect subnet mask.

D. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.

E. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

F. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA

Show Answer

Explanations

Click on the arrows to vote for the correct answer

A. B. C. D. E. F.

From the output we can see that there is a problem with the Serial 0/0 interface. It is enabled, but the line protocol is down.

The could be a result of mismatched encapsulation or the interface not receiving a clock signal from the CSU/DSU.

Prev Question Next Question