Refer to the exhibit.What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)

Question

Exam-Answer · Accepted Answer

Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk

Question 815 of 952 from exam 200-125: Cisco Certified Network Associate Exam

Question

Answers

Explanations